RSS .92| RSS 2.0| ATOM 0.3
  • Home
  •  

    VAAI and supportability

    VAAI, or vStorage API for Array Integration, is an industry answer to offload specific storage requests from the ESX(i) servers to the storage array.

    VAAI implements only three functions, as described in VMware KB1021976:

    • Atomic Test & Set
    • Clone Blocks/Full Copy/XCOPY
    • Zero Blocks/Write Same

    As it turns out, only certain arrays support VAAI.  Since VAAI is on by default, at least in 4.1, the hosts will send VAAI commands to the array.  The array will usually say they are not supported, and then ESX will fall back to regular SCSI commands.  However, there seems to be occasions when SAN devices do not support VAAI, but can apparently cause failure states.  I’ve seen it.  It’s true.

    Now, how do we determine if the SAN handles VAAI?  SSH to your servers and run the following command, via KB102197:

    esxcfg-scsidevs -l | egrep “Display Name:|VAAI Status:”

    If the array does not support VAAI, you will most likely see results such as:

    Display Name: <Vendor> Fibre Channel Disk (naa.600*)
    VAAI Status: unknown

    VMware KB1033665 tells us how to disable VAAI both from the ESX(i) command line, as well as the vSphere Remote CLI

    ESX(i) command line:

    esxcfg-advcfg -s 0 /DataMover/HardwareAcceleratedMove

    esxcfg-advcfg -s 0 /DataMover/HardwareAcceleratedInit

    esxcfg-advcfg -s 0 /VMFS3/HardwareAcceleratedLocking

    -s 0 will disable, -s 1 will enable. You can also substitute -s 0 with -g to see the current setting.

    Remote CLI:

    vicfg-advcfg.pl –server <servername> –username <possibly root> –password <password> -s 0 /DataMover/HardwareAcceleratedMove

    vicfg-advcfg.pl –server <servername> –username <possibly root> –password <password> -s 0 /DataMover/HardwareAcceleratedInit

    vicfg-advcfg.pl –server <servername> –username <possibly root> –password <password> -s 0 /DataMover/VMFS3/HardwareAcceleratedLocking

    where items in < > are dependent on your specific configuration.  You can again substitute -s 0 with -g to see the current setting.

     

    Leave a Reply

    Your email address will not be published. Required fields are marked *